Bathtub Leakage – Causes, Findings and Fixing

What would cause a bathtub to leak?

The plumbing fixtures in a bathroom are many, and they frequently leak. The bathtub has been the source of some of the grubbiest leaks. Bathtub leaks can go undiscovered for quite a while, which can cause severe water damage to a property or apartment and other complications including infestation, chemical hazards, and even electrocution. It’s easy to mistakenly determine the source of a leak because the bathroom has so much plumbing. Usually, water will flow down a pipe’s surface for a considerable distance before beginning to drip and become apparent. This can make a leak in your shower’s plumbing system appear to emanate from the bathtub. Examine the leak while several fixtures are functioning to accurately pinpoint the leak’s source before you conduct any repair work. REPAIR A BATHTUB

Which types of leaks are most common and how do you can repair them?

Faucet Leaks

The most frequent and simplest to fix type of tub leak is faucet leak. Many faucet leaks are caused by dried-out, aged rubber washers inside the faucet assembly.

Repair: Turning off your water supply completely will allow you to begin the faucet repair process. Remove the plastic caps from the faucet’s centre after that. The faucet handle should then be disconnected using a screwdriver. Remove the packing nut holding the faucet in place with a wrench. Secure your new fixtures after replacing the stem washers. Once you’re through, remember to switch your water supply back on.

Drain Leaks

The plumbing behind the drain itself may have an issue that’s causing the leak; in order to remedy it, a plumber will probably be needed. However, it’s likely that the drain assembly’s seal surrounding the leak is insufficient.

Repair: It’s possible that the plumber’s putty on the inside of the stopper is beginning to rub off if the water in your tub is draining swiftly. Put some putty back on after removing the drain plug with a pair of screwdrivers. This is available from the neighborhood hardware store.

Grouting Problems

Often, bathtub leaks are caused by compression of the grout around the tiles in the area where water from the shower hits them rather than from the plumbing or drainage system. When shower spray strikes bathroom tiles, it sometimes gets behind them and flows down the back of the tiles onto the floor.

Repair: Find the leak and clean the area around it to restore the grout. If you notice a crack, caulk the crevices to stop the leak. Wait about three hours to let the sealant completely cure before turning on the water.

LOOKING FOR FAUCET & LEAK REPAIR IN  ILLINOIS?

How do you check bathtub for leaks?

Before you can fix the leak, you must find it. Checking to see if water is dripping from either spot can tell you whether or not your faucet or grout is leaking. Wipe the surface of the tub until it is fully dry, then line the area with newspaper to check for leaks. You should keep an eye out for any portions of the newspaper that start to become wet as you fill the tub.

Fill the tub to the brim with water to test the drain. Carefully listen for the sound of water leaking out after it has been filled. It’s possible that the drain assembly isn’t properly fitted if you hear those noises and notice the water beginning to escape.

What is the first step if there is a bathtub Leakage?

It is important that you take action as soon as you identify any leak in your bathroom, no matter how big or tiny. One of the major dangers of ignoring a leak is that dangerous mould may start to spread. Mould not only looks bad, but it might also be harmful to your health. Mould can lead to or exacerbate respiratory infections, as well as headaches, fatigue, flu-like symptoms and allergy symptoms. It can result in quite significant health conditions if you are exposed for a long time. On a more light-hearted note, catching the leak soon helps guarantee that it doesn’t cause too much structural damage to your house.

LOOKING FOR FAUCET & LEAK REPAIR IN  ILLINOIS?